Microbial controls on the origin and evolution of coal seam gases and production waters of theWalloonSubgroup;SuratBasin, Australia

澳大利亚Surat盆地Walloon子组煤层气及伴生水起源与演化之微生物控制

International Journal of Coal Geology, Volumes 147–148, 1 August 2015, Pages 85-104

Abstract:The Walloon Subgroup coal seam gas (CSG) play in the Surat Basin, Queensland, is Australia's pre-eminent onshore gas field. Concerted multi-disciplinary research is underway investigating the distribution, origin and composition of waters and gases in this dominantly microbial CSG reservoir, to guide both continued production and potential microbially enhanced coal bed methane (MECoM) applications. However, prior to the present research, a detailed study of co-produced waters and gases from across the Surat Basin was not available in the public domain. This study tested whether co-produced water compositional and stable isotopic data show relationships with production gas stable isotope compositions, to elucidate further evidence for microbial CO2 reduction and explore the down-dip geochemical evolution of Walloon coal bed waters and gases. A total of 41 wells were sampled with 50 water and 25 gas samples spanning the 3 major production areas of the Surat Basin. Detailed isotopic and hydrochemical analysis of these samples revealed distinct spatial trends between the different production locales. Water compositions were distinct for each of the production regions reflecting the different lithologies of adjacent recharge zones, differing fluid–rock interactions, likely different microbial consortia, and the extent of methanogenesis. On the western side of the basin near Roma, waters were the ‘freshest’ with the lowest median values for alkalinity (861 mg/L), and Cl− (588 mg/L) and a δ13CDIC of 14.2‰. On the eastern side of the basin, the Kogan Nose waters were the most saline with the highest median values for Na+ (1955 mg/L), Cl− (2280 mg/L) and δ13CDIC (20.0‰). Also in the east, in the present gas fairway, the Undulla Nose waters had the highest median alkalinity (1841 mg/L) and were found to have a Na+ excess (median = 1050 mg/L) and a lower than expected median δ13CDIC (14.0‰). Co-mingled, produced methane carbon isotope values (δ13C − 57.0‰ to − 44.5‰) from both the upper (Juandah) and lower (Taroom) coal measures plot within the mixed ‘thermogenic/microbial’ genetic field. By contrast, deuterium isotopic difference [Δ2H(H2O–CH4)] values and cross-plots of δ2H–H2O and δ18O–H2O suggest that microbially mediated CO2 reduction is the dominant methane generation process in situ. At a given depth, the Undulla Nose waters in the east are more depleted in 2H and 18O than elsewhere in the Surat Basin, which may suggest these samples have been more heavily impacted by water–rock–microbial reactions. 14C values from the 3 production regions (0.115 to 1.769 pmC; age: 32,400 to > 50,000 years before present (B.P.)) suggest that Walloon coals likely recharged in the last ~ 50,000 years (limit of radiocarbon dating). Consistent with these dates, δ2H–H2O and δ18O–H2O values for the Surat Basin (δ2H − 32‰ to − 56‰, δ18O − 5.9‰ to − 9.0‰) echo the stable isotopic composition of meteoric waters during the initial part of the last glacial period in southeast Queensland. Based on a strong correlation between δ2H–CH4 and δ2H–H2O, we suggest that methane was generated since the Late Pleistocene. PCA analysis showed a degree of positive correlation between total alkalinity and both the δ13CDIC (median 14.2‰) and δ13C–CH4 (median − 52.1‰) vectors that is consistent with finite reservoir effects. The results inform ongoing studies of gas distribution and origins and MECoM potential in the Surat Basin, and underpin a broader study examining aquifer interactions.

Use oftemperature logsin coal seam gas reservoirs: Application to the Sydney Basin, Australia

温度测量在煤层气藏中的运用：在澳大利亚悉尼盆地的应用

International Journal of Coal Geology, Volume 143, 1 April 2015, Pages 68-77

Abstract:This study examines the relationship between borehole temperature logs and gas distribution in coal seams, both spatially and with depth. Temperature logs are often utilized in hydrogeology to monitor groundwater flow which can introduce methanogenic consortia into coal seams, resulting in the generation and accumulation of coal seam gases. Areas of hydraulic connectivity, characterized by open cleats and fractures, provide a pathway for the meteoric influx, whereas tight, mineralized sections of strata prohibit vertical flow and have the potential to trap coal seam gases, or to limit the influx of methanogens and the generation of secondary, biogenic methane. The combination of these concepts raises the possibility of utilizing temperature logs for mapping coal seam gas distributions and assisting exploration activities. Wireline temperature logs are inexpensive to obtain as part of any exploration, production or monitoring program, but provide information pertaining to flow regimes and in situ geological environments. A case study is presented from the Sydney Basin of Australia to demonstrate the types of analyses and interpretations relating to coal seam gas distribution that may be gleaned from temperature log datasets.

Stable Isotopes of Lithium asIndicators of Coal Seam Gas-bearing Aquifers

作为含煤层气含水层指标（数）的锂稳定同位素

Procedia Earth and Planetary Science, Volume 13, 2015, Pages 278-281

Abstract:In this study lithium isotopes were used in combination with hydrochemistry to investigate interactions between coal-seam-gas bearing sedimentary bedrock aquifers and surrounding basalt and alluvial aquifers in a large catchment in eastern Australia. Understanding groundwater transport and aquifer connectivity is critical to managing coal seam gas (or coal bed methane) developments, because large volumes of water need to be extracted in order to release the sorbed gas; however, to date lithium isotopes have not been applied to coal seam gas groundwater management problems and no information on the δ7Li of coal or coal-seam groundwater is available. Li/Cl and Li/Na ratios in the coal-bearing and sedimentary bedrock aquifers are distinct (>0.0001) from alluvial and basalt aquifers (<0.0001). Preliminary δ7Li results for coal measure samples are typically between 7 and 11‰; many of these samples also contain methane, and can therefore be expected to be influenced by coal and the early stages methanogenesis. Interestingly the coal measure with lowest δ7Li value occurs in an area where the coal measures outcrop and direct recharge is likely, with nearby basalt groundwater having much higher δ7Li values (δ7Li>18‰). Preliminary lithium isotope results show that δ7Li may be effective in distinguishing groundwater flow paths in the coal-bearing aquifer from basalt aquifers, and from a transitional zone between the alluvium and underlying coal measures. Further lithium isotope analysis is being carried out to: a) compare the δ7Li between alluvial, basalt and coal-bearing aquifers to further investigate aquifer connectivity; b) to describe δ7Li for CSG production waters with low- and high-methane groundwater in the coal-bearing aquifer; c) to describe the δ7Li from coal and basalt leachate.

Mathematical modelling of gas production andcompositional shiftof a CSG (coal seam gas) field: Local model development

煤层气田气产与组分变化数学模拟：局部模型开发

Energy, Volume 88, August 2015, Pages 621-635

Abstract:In this work we discuss the development of a mathematical model to predict the shift in gas composition observed over time from a producing CSG (coal seam gas) well, and investigate the effect that physical properties of the coal seam have on gas production. A detailed (local) one-dimensional, two-scale mathematical model of a coal seam has been developed. The model describes the competitive adsorption and desorption of three gas species (CH4, CO2 and N2) within a microscopic, porous coal matrix structure. The (diffusive) flux of these gases between the coal matrices (microscale) and a cleat network (macroscale) is accounted for in the model. The cleat network is modelled as a one-dimensional, volume averaged, porous domain that extends radially from a central well. Diffusive and advective transport of the gases occurs within the cleat network, which also contains liquid water that can be advectively transported. The water and gas phases are assumed to be immiscible. The driving force for the advection in the gas and liquid phases is taken to be a pressure gradient with capillarity also accounted for. In addition, the relative permeabilities of the water and gas phases are considered as functions of the degree of water saturation.

Relationships between major ions in coal seam gas groundwaters: Examples from theSurat and Clarence-Moreton basins

煤层气地下水中主要离子之间的关系：Surat及 Clarence-Moreton盆地实例研究

International Journal of Coal Geology, Volume 137, 1 January 2015, Pages 77-91

Abstract:Using a combination of multivariate statistical techniques and the graphical assessment of major ion ratios, the influences on hydrochemical variability of coal seam gas (or coal bed methane) groundwaters from several sites in the Surat and Clarence-Moreton basins in Queensland, Australia, were investigated. Several characteristic relationships between major ions were observed: 1) strong positive linear correlation between the Na/Cl and alkalinity/Cl ratios; 2) an exponentially decaying trend between the Na/Cl and Na/alkalinity ratios; 3) inverse linear relationships between increasing chloride concentrations and decreasing pH for high salinity groundwaters; and 4) high residual alkalinity for lower salinity waters, and an inverse relationship between decreasing residual alkalinity and increasing chloride concentrations for more saline waters. The interpretation of the hydrochemical data provides invaluable insights into the hydrochemical evolution of coal seam gas (CSG) groundwaters that considers both the source of major ions in coals and the influence of microbial activity. Elevated chloride and sodium concentrations in more saline groundwaters appear to be influenced by organic-bound chlorine held in the coal matrix; a sodium and chloride ion source that has largely been neglected in previous CSG groundwater studies. However, contrastingly high concentrations of bicarbonate in low salinity waters could not be explained, and are possibly associated with a number of different factors such as coal degradation, methanogenic processes, the evolution of high-bicarbonate NaHCO3 water types earlier on in the evolutionary pathway, and variability in gas reservoir characteristics. Using recently published data for CSG groundwaters in different basins, the characteristic major ion relationships identified for new data presented in this study were also observed in other CSG groundwaters from Australia, as well as for those in the Illinois Basin in the USA. This observation suggests that where coal maceral content and the dominant methanogenic pathway are similar, and where organic-bound chlorine is relatively abundant, distinct hydrochemical responses may be observed. Comparisons with published data of other NaHCO3 water types in non-CSG environments suggest that these characteristic major ion relationships described here can: i) serve as an indicator of potential CSG groundwaters in certain coal-bearing aquifers that contain methane; and ii) help in the development of strategic sampling programmes for CSG exploration and to monitor potential impacts of CSG activities on groundwater resources.